nrf24 is not working on pirata board

[hulaixll]

**Describe the bug:
when I turn on the nrf 24 and change the configuration to spi, my stick starts lagging with the sd card connected, and if you take it out, the nrf24 starts working. I use firmware 12

Steps To Reproducе:
Turned on the stick >turned on the nrf24 toggle switch>switched the config to spi >the stick starts lagging

**Expected behavior
I want nrf24 to work together with the SD card.

**Actual behavior:
the NRF24 does not work with the SD card.

[bmorcelli]

What is the schematics used in your circuit?

[hulaixll]

What is the schematics used in your circuit?

I'm using your board

[hulaixll]

What is the schematics used in your circuit?

I'm using your board.

I have nrf24 not found

[bmorcelli]

There are 2 things to observe...

First: the Grove port in the current gerber file is "mirrored" so you must twist the cable to connect.. the squared solder point is the GND

Second: the switches must be it the right positions..

Can you send me a photo, so I can check these points?

Back and front of the board, if possible

[hulaixll]

Следует обратить внимание на две вещи...

Во-первых: порт Grove в текущем файле Gerber «зеркальный», поэтому для подключения необходимо перекрутить кабель. Квадратная точка пайки — это GND

Второе: переключатели должны быть установлены в правильных положениях..

Можете прислать мне фото, чтобы я мог проверить эти моменты?

Сзади и спереди платы, если возможно

I know that you need to twist the groove cable

[bmorcelli]

Try putting the nrf24 on the cc1101 place and use the cc1101 switch

Your soldering points are not very good, except on SMD sdcard and resistors..

[hulaixll]

Попробуйте установить nrf24 на место cc1101 и использовать переключатель cc1101

Ваши навыки пайки не очень хороши, за исключением работы с SMD-картами памяти и резисторами.

this was my first soldering experience. I'll try your theory now

[hulaixll]

Try putting the nrf24 on the cc1101 place and use the cc1101 switch

Your soldering points are not very good, except on SMD sdcard and resistors..

the stick also starts lagging, although there are no lags when using the cc1101

[hulaixll]

Try putting the nrf24 on the cc1101 place and use the cc1101 switch
Your soldering points are not very good, except on SMD sdcard and resistors..

the stick also starts lagging, although there are no lags when using the cc1101

if you take out the SD card, then the NRF is working, but not at full capacity, it cannot connect Bluetooth only to Wi-Fi

[bmorcelli]

You may be having issues with your transistor, then..

If you remove the nRF24, SDCard works normally?

[hulaixll]

Возможно, у вас проблемы с транзистором, тогда...

Если вы удалите nRF24, SD-карта будет работать нормально?

Yes, sdcard work normally

[bmorcelli]

Try other nRF24.. probably this one you have is damages somehow

[hulaixll]

Попробуйте другой nRF24. Возможно, этот каким-то образом повреждён

this NRF24 works because if i connect jumpers through wires, it jammers everything