[Bug] Deauth attack not working on Smoochiee board - v1.12

[sanzxprojectid]

Describe the bug:
The Deauth attack feature is non-functional on the Smoochiee board running firmware v1.12. When initiating the attack, it appears to run but does not effectively disconnect the target from the network.

Steps To Reproduce:

1. Flash firmware version 1.12 on the Smoochiee board.
2. Navigate to the WiFi / Attack menu.
3. Scan for Access Points and select a target.
4. Select "Deauth" and start the attack.

• Device used: Smoochiee Board

Expected behavior:
The device should send deauthentication packets, causing the target client to disconnect from the Access Point immediately.

Actual behavior:
The attack interface shows it is active, but the target device remains connected to the WiFi network without interruption.

Additional context / logs:
Firmware Version: 1.12
Board: Smoochiee Board

[bmorcelli]

Is the target connected to a 2.4Ghz network? (ESP32-S3 only works in this frequency band)
is the network WPA2? (WPA2 Enterprise and WPA3 are immune to this kind of attack)

[sanzxprojectid]

Is the target connected to a 2.4Ghz network? (ESP32-S3 only works in this frequency band)
is the network WPA2? (WPA2 Enterprise and WPA3 are immune to this kind of attack)

yes, target connected to 2,4 GHz AP band