What model are the two 6-pin connectors for the CAN-BUS

[abassign]

What model are the two 6-pin connectors for the CAN-BUS and voltages 24 and 48? Is it possible to find them on Amazon?

[rbricheno]

I have one of these boards in hand and measured the connectors to work this out.

They are "43025-0600" 6 circuit Micro-fit 3.0 connectors as described here: https://www.utmel.com/components/43025-0800-micro-fit-3-0-receptacle-housing-dual-row-drawing-datasheet-and-equivalents?id=1277

I took a photograph of the board next to some calipers which you can see here: https://imgur.com/a/ZejbaVU

It might also be worth noting that when I bought the board it was supplied with a cable that had one end pre-terminated in the correct 6 circuit block to connect into this. From what I can tell that has two 18AWG wires (suggested to be used for for 48V and a matching ground), and the remaining wires 22AWG.