Builder when in quarry mode does not go past Y=0 on the 1.18 version of Minecraft

[NuclearTeddyBear530]

Issue description: Using the new Direwolf20 1.18 mod pack, Mining in JAMD mining Dimension, Builder when in quarry mode does not go past Y=0 on the 1.18 version of Minecraft

Steps to reproduce: Place a quarry builder, define area and turn on

Versions:

• Minecraft: 1.18.2
• Forge: 40.1.19
• CompatLayer (only if on Minecraft 1.10 or 1.11):
• McJtyLib: 1.18-6.0.13
• RFTools: Builder 1.18-4.0.10
• RFTools: Base 1.18-3.0.7

Possibly incompatible mods and versions: None

Relevant logs, if any:

[McJty]

BTW. This issue is on the wrong github. RFToolsBuilder has its own github. You should post there. I almost couldn't find this issue listed at the right spot

[McJty]

I cannot reproduce this in the overworld. Are you sure that mining dimension actually goes below 0?

[NuclearTeddyBear530]

It does go to -64 as I've mined down to bedrock manually but maybe it's just the fact that it is another dimension. I will try it in the overworld on this modpack and see if there's some other conflict. Thanks for looking into it

…

On Tue, May 24, 2022, 6:47 AM McJty ***@***.***> wrote: I cannot reproduce this in the overworld. Are you sure that mining dimension actually goes below 0? [image: image] <https://user-images.githubusercontent.com/8188472/170017687-db8695d7-eece-4a63-b8ac-346a0b091b29.png> — Reply to this email directly, view it on GitHub <#2168 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AZIQZ6XHBND72IPA42ZYYZDVLSXVZANCNFSM5WSGHDQA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[NuclearTeddyBear530]

I set it up in the overworld and it still stops at Y=0 and starts over with the next chunk. There must be something in the Direwolf20 1.18 modpack that causes it. Thanks for checking

[McJty]

Can you show me the gui of your builder as well as the quarry card that you're using? Also the Y position of the builder

[NuclearTeddyBear530]

Here you go. Hopefully that helps. If you need something else let me know.