0.1.0 - new API

This is the pre-release 0.1.0. It is a huge update despite the 0.0.7 pre-release.
Following you can find the major new API.

Note: this micropython package requires at least Arduino_AlvikCarrier version 0.2.0

Robot related commands:

• begin, initialize the robot

• rotate(<deg>), rotate the robot of deg, you can also set blocking to false and check accomplishment with is_target_reached()

• move(<mm>), drive straight the robot of mm, you can also set blocking to false and check accomplishment with is_target_reached()

• drive(<mm/s> , <deg/s>), set linear velocity and angular velocity of the robot

• (mm/s, deg/s) get_drive_speed(), get drive data

• (x, y, theta) = get_pose(), get the pose of the robot in the 2D environment

• reset_pose(<x>, <y>, <theta>), reset the pose of the robot, by default x ,y, theta are 0

• set_wheels_speed(<left rpm>, <right rpm>), replace old set_speeds()

• (<left rpm>, <right rpm>) = get_wheels_speed(), replace old get_speeds()

• (ax, ay, az, gx, gy, gz) = get_imu(), get data from IMU in g and deg/s

• (ax, ay, az) = get_accelerations(), get accelerometer data in g

• (gx, gy, gz) = get_gyros(), get angular velocity from gyroscope data in deg/s

• (roll, pitch, yaw) = get_orientation(), get orientation data from sensor fusioning

Wheel related commands:

• set_position(<deg>), set the absolute position of the wheel in degrees
• (deg) get_position(), get the position of the wheel in degrees
• reset(<initial position>), reset the absolute position of the wheel in degrees, intial position is 0 by default
• stop(), brake the wheel
• set_speed(<rpm>), set wheel speed in RPM
• (rpm) = get_speed(), get wheel speed in RPM

Other new commands:

• <led>.set_color(<R>, <G>, <B>), set color on led with boolean R, G, B values
• (R, G, B) = get_color_raw(), get color in raw format

0.0.7 - first release

This release is preliminary.

Check readme to flash firmware and install the library