Replies: 5 comments 1 reply
-
|
Did you wire the connectors according to the instructions in the Wiki page? If there is no communication at all, first check the CAN bus termination. Is the 180 Ohm HVIL resistor in place? If the above is ok, can you upload a log of the CAN bus? Preferably with a CAN reader, since the logging function in Battery Emulator will miss frames. |
Beta Was this translation helpful? Give feedback.
-
|
Good afternoon. Sorry for the delay in replying. The battery isn't near me. I don't know yet where to look for the problem. Thanks for any tips. |
Beta Was this translation helpful? Give feedback.
-
|
Those screenshots don't look like the Tesla Legacy implementation, I think you selected the wrong battery type in your settings. |
Beta Was this translation helpful? Give feedback.
-
|
Hi everyone. The problem was with the BMS board itself. After replacing it, the battery established normal communication and data was read. I'm preparing the wiring and will connect the battery to the inverter. Thanks everyone for your help. |
Beta Was this translation helpful? Give feedback.
-
|
Hi. Thanks to everyone who responded. The battery started working. |
Beta Was this translation helpful? Give feedback.


Uh oh!
There was an error while loading. Please reload this page.
-
Connecting the battery to the Model S 2012-2020. I'm connecting according to the instructions, but the battery isn't connecting. I checked the Telsa service manual—everything is correct. Is there a secret?



Beta Was this translation helpful? Give feedback.
All reactions