v10.7.0

[dalathegreat]

What's Changed 📦

This release is a stability update, that contains mostly fixes but also important SAFETY ⚠️ updates

Taking this release into use ⚙️

Important

In order to OTA update to this version, you already need to be on a v10 release!

Note that v10 was a major new release of the Battery-Emulator software. The first time when taking a v10 version into use, you are required to perform an initial one time USB setup via this webpage! This is because we changed the flash frequencies, partitioning layouts and other under the hood changes to ensure longterm system stability. After any v10 has been installed via USB, following 10.X.X releases can be updated over the air. Sorry for the inconvenience!

Quickstart video: https://youtu.be/sR3t7j0R9Z0

Setting up a board for the first time? Use this webpage to flash the board!

Battery 🔋

• Legacy Tesla: Add BMS reset to More Battery Info page, to allow recovery of faulted BMS by @dalathegreat in Legacy Tesla: Add BMS reset #2259
• Tesla S/3/X/Y: Change how low 12V is triggered by @roy13 in Tesla S/3/X/Y: Change how low 12V is triggered #2263
• Tesla S/3/X/Y: Add automatic capacity writing based on vehicle selection by @dalathegreat in Tesla: Add automatic capacity writing based on vehicle selection #2218
• Feature: Make rampdown start-% configurable for all integrations using estimated charge/discharge by @dalathegreat in Feature: Make rampdown configurable for custom BMS + Geely SEA rampdown #2159
• Geely SEA: Add estimated charge/discharge setting until CAN values can be found by @dalathegreat in Feature: Make rampdown configurable for custom BMS + Geely SEA rampdown #2159

Inverter ⚡

• Fronius: Increase comm timeout from 3min to 5min by @dalathegreat in Fronius: Increase comm timeout from 3min to 5min #2276
• SMA: Increase CAN timeout on SMA integrations to avoid contactor opening by @dalathegreat in SMA: Increase CAN timeout on SMA integrations to avoid contactor opening #2275
• Pylon RS485: Make integration always send current set charge/discharge limits by @dalathegreat in Pylon RS485: Make integration always send current set charge/discharge limits #2267

Hardware 🤖

• Screen: Fix missing SOC% for extra batteries by @dalathegreat in Screen: Fix missing SOC% for extra batteries #2256

Housekeeping 🧹

• Library 📚 Update ArduinoJson to v7.4.3 by @dalathegreat in Library 📚 Update ArduinoJson to v7.4.3 #2258
• Improvement: Add Events page link for totally faulted systems by @dalathegreat in Improvement: Add Events page link for totally faulted systems #2269
• Bugfix: Stop Preferences reporting bogus errors via serial on boot by @jonny5532 in Fix: stop Preferences reporting bogus errors #2281

Full Changelog: v10.6.0...v10.7.0

---

This discussion was created from the release v10.7.0.