You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
For some reason, the cron min is momentarily writing pin ON when the heater control is should be off.
The pump and loop valve are the same relay (one connected to the NC, the other NO side of the relay) but it's also flipping the Pump relay too. Once a minute that relay is flicking on/off as the cron run over the code. I can't seem to figure out what is doing that.
The text was updated successfully, but these errors were encountered:
For some reason, the cron min is momentarily writing pin ON when the heater control is should be off.
The pump and loop valve are the same relay (one connected to the NC, the other NO side of the relay) but it's also flipping the Pump relay too. Once a minute that relay is flicking on/off as the cron run over the code. I can't seem to figure out what is doing that.
The text was updated successfully, but these errors were encountered: