FlashForge Adventure 4 - Klipper + BTT SKR Mini E3 V3 Upgrade
Required Components:
BigTree Tech SKR Mini E3 v3
Printig is stable with 150mm/sec and 3000mm/sec acceleration. (Tested with 300mm/sec and 10000mm/sec works good also for ABS)
Quality of printing is perfect.
- klipper.bin you can flash directly on board
- macros.cfg are helpful to test your printer (thanks to dJOS1475)
- mainsail.cfg for Mainsail
- moonraker.cfg for Moonraker
- printer.cfg for Flashforge Adventure 4 special config
Sensorless homing for X-Y
Home sensor used for Y
Stock extruder / hotend / bed heater works fine