Update platformio.ini

ESP32_AP-Flasher/platformio.ini

@@ -260,15 +260,16 @@ board_build.psram_type=qspi_opi
 board_upload.maximum_size = 16777216
 board_upload.maximum_ram_size = 327680
 board_upload.flash_size = 16MB
-
+; ----------------------------------------------------------------------------------------
+; !!! this configuration expects an ESP32-S3 16MB Flash 8MB RAM
+; ----------------------------------------------------------------------------------------
 [env:ESP32_S3_16_8_LILYGO_AP]
 board = esp32-s3-devkitc-1
 board_build.partitions = large_spiffs_16MB.csv
 monitor_dtr = 0
 monitor_rts = 0
 build_unflags =
 	-std=gnu++11
-    -D ARDUINO_USB_MODE=1
     -D CONFIG_MBEDTLS_INTERNAL_MEM_ALLOC=y
     ;-D ILI9341_DRIVER
 lib_deps = ${env.lib_deps}
@@ -279,15 +280,14 @@ build_flags =
 	-D HAS_TFT
 	-D HAS_LILYGO_TPANEL
 	-D CORE_DEBUG_LEVEL=1
-        -D ARDUINO_USB_MODE=0
-	-D ARDUINO_USB_CDC_ON_BOOT=1
+        -D ARDUINO_USB_CDC_ON_BOOT=1
 	-D CONFIG_ESP32S3_SPIRAM_SUPPORT=1
 	-D CONFIG_SPIRAM_USE_MALLOC=1
 	-D POWER_NO_SOFT_POWER
 	-D BOARD_HAS_PSRAM
 	-D CONFIG_MBEDTLS_EXTERNAL_MEM_ALLOC=y
 	-D HAS_BLE_WRITER
-    -D FLASHER_AP_SS=-1
+        -D FLASHER_AP_SS=-1
 	-D FLASHER_AP_CLK=-1
 	-D FLASHER_AP_MOSI=-1
 	-D FLASHER_AP_MISO=-1
@@ -305,8 +305,8 @@ build_flags =
 	-D LOAD_FONT2
 	-D MD5_ENABLED=1
 	-D SERIAL_FLASHER_INTERFACE_UART=1
-	-D SERIAL_FLASHER_BOOT_HOLD_TIME_MS=50
-	-D SERIAL_FLASHER_RESET_HOLD_TIME_MS=100
+	-D SERIAL_FLASHER_BOOT_HOLD_TIME_MS=200
+	-D SERIAL_FLASHER_RESET_HOLD_TIME_MS=200
 build_src_filter = 
 	+<*>-<usbflasher.cpp>-<swd.cpp>-<webflasher.cpp>
 board_build.flash_mode=qio